Standard Features
Emergency car lighting
An emergency light switches on automatically in the event of a power failure, providing illumination within the car. The emergency light will allow any passengers inside the car to utilize the interphone or the alarm bell to alert the building superintendent. Full collective operation This facility provides for the landing and car calls to be recorded in a logical sequence according to the direction of the car travel. This system handles the inter-floor traffic very well and is suited for most application Attendant service In attendant service, if the Close Door Button is released before the doors are closed, the doors will reopen. The car will start immediately after the doors have been closed. Fire emergency return When the building’s fire or smoke detectors are activated, all calls are cancelled and all the elevators will immediately travel to the main lobby or a pre-designated floor and park there with the door fully open. However the electrical signal that indicates the actuation of the fire sensors must be supplied to the elevator controller by others or the fire alarm switch provided on ground floor be activated. Car light & fan automatically shut off Elevators can be installed with an energy saving feature that automatically switches off the car internal lighting and ventilation fans when no calls are registered after a predetermined (programmable) period of time. Interphone ( only for Passenger lifts) In case of emergencies, the interphone installed inside the car can direct communication with rescue personnel in the motor room or car top. The interphone is activated by simply pressing the interphone button on the car operation panel. Variable Voltage Variable frequency drive (For passenger elevator). This facilitates soft start, soft stopping and good ride quality. In addition to facilitating good control of the elevator this system facilitates high energy savings i.e. low consumption of power and improves the life of the mechanical systems and brakes extensively. Fault information recorded. 20 last fault information’s are recorded to check what happened during a break down. Lifts with Automatic Doors. • Door protective device It is a multi-beam light ray type door protective device, which surveys the car entrance. When a passenger or an object passes the entrance, the elevator will stop the doors at the point of contact and re-open the car doors immediately. • Door holding time. The door open time can be programmed and the time delay set in the system. • The lift can be designed to go out of service if the doors are kept open for a long time. • A delay to the start the lift after the doors are closed (say 0.2 to 2.0 sec) can be programmed. • Choice for doors to reopen when the landing floor button is pressed. This mode can be deactivated for commercial buildings. Over speed protection (Down direction) It can ensure the car’s running speed in normal range In case of the car starts traveling faster than its rated speed. The governor activates the emergency safety brakes fitted in the car. Arrival chime An electronic chime provides an audio signal to inform waiting passengers of the arrival of the elevator car at each floor. The chime can be mounted on the top or bottom of the car. Emergency Alarm A battery operated alarm bell is provided to allow passenger to alert the building superintendent. Maximum Call Registration Limit Maximum car calls to be registered at one time to avoid misuse, improve traffic efficiency and avoid redundant stopping of the car. Parking Floors To improve efficiency and save time the elevator car can be programmed to return to a predetermined floor after remaining idle. The idle time can also be programmed. |
Optional Features
Front-back Door Openings
All kinds of door service includes front door, back door and front & back door openings. Freight elevators can also have 90° opening. Voice Anunciator All kinds of information that includes floor, direction and others will be spoken out to remind passenger in two languages. Group Control – Duplex Controls The group control system for two or more elevators. The highest refined knowledge and experience harnessed into the field of group control will be incorporated into the microprocessors, allowing the car to the move to the most used location, and thereby providing superb elevator efficiency and optimum service. Security Access With Swipe Card To access the lift from a particulars floor through a swipe card or to activate a certain floor through a swipe card. Handicap It is special for those people who are handicapped, which include Voice Anunciator with handrail, back mirror and horizontal push button station with Braille buttons. Automatic Rescue Device During power failure, the automatic rescue device (ARD) converts stored energy from it bank of rechargeable batteries to drive the elevator car to the nearest floor and opens the elevator doors to let the passengers out. The ARD optimizes the use of the stored battery power by selecting the direction which requires the least effort. Auxiliary Cop(Optional For Wide Car) It is optional according to user’s demand. Main COP at one side and auxiliary COP at the other side of the front opening. Separated Landing Display Big screen dot matrix or LCD display or arrive hall lantern. Bi-directional Over speed protection (up direction) The features prevents car from traveling at a higher speed than the rated speed in both downward and upward direction. Over Load Protection This device offers the following additional function other than overload protection. a)Minimum load function- To prevent a child from operating the elevator. b) On full load the landing calls will not be accepted. Back Ground Music Function Music is played inside the car when elevator is working. Phase Reversal correction This device can maintain a proper phase sequence in case the sequence of the input supply changes. Video Remote monitoring A camera can be fitted in the car for remote surveillance. |